代碼 P10-10304: I3 Overcurr UPos
問題描述與安全警告
Allen-Bradley PowerFlex 750 Drive 觸發了嚴重的 I3 Overcurr UPos 警報。需要由合格的操作員或維修技師立即處理，以防止在製造週期中對設備造成二次損壞或導致零件報廢。在接觸電氣控制箱之前，請務必確保遵循標準安全和停機掛牌 (LOTO) 程序。
官方故障排除步驟
Type: Resettable Fault Coast Y Y An instantaneous overcurrent (IOC) has occurred in the U, V, or W phase, positive or negative leg. • Reduce the mechanical load. • Check the motor and connections. • With motor disconnected, run the drive in open loop, in V/Hz mode and check for sufficient output phase-to-phase voltages. If an IOC occurs immediately after restarting the drive, check the appropriate current sensor. • Check the power and signal connections to the gate driver board for the phase that is identified, or replace it. The IGBT could also have failed open (and the opposite leg is receiving excess current).
Source: Allen-Bradley PowerFlex 750-Series AC Drives Programming Manual (750-PM001)
Last reviewed: 2026-07-01 · Verified against the manufacturer’s official documentation.
關於 Allen-Bradley PowerFlex 750 Drive 警報
由 Allen-Bradley 製造的工業控制器具有廣泛的診斷系統，用於保護內部電路和機械連桿。當 PowerFlex 750 Drive 出現類似 P10-10304 的錯誤代碼時，通常表示指令值與實際感測器回饋之間存在不匹配。
Have a better solution?
Help the industrial community by sharing your repair experience for code P10-10304.
Need a searchable reference for more Allen-Bradley PowerFlex 750 Drive manuals?
We structure equipment manuals into searchable code, title, cause, solution, safety note, and source-reference data. Send a PDF and example searched codes when you need public pages, private search, or structured exports.
Space reserved for Google AdSense / Industrial Affiliate Links
Monetization target for 2026