代碼 700112: Pm not done

Maintenance has not been carried out, despite several indications. The machine urgently requires maintenance. In the diagnostics menu Maintenance cycles, it is shown what maintenance is required. The error message is displayed immediately, but the machining program still continues until the program end. Further operation of the machine remains blocked. Optional: The red signal indicator flashes (1 Hz), and the white signal indicator continues to flash continuously. (Cycle: ON = 0.4 sec / pause = 2 sec) These displays remain visible until the completion of maintenance is acknowledged. Error messages Maintenance Pm not done 1. In the diagnostics menu Maintenance cycles, check which maintenance is required. The "hours display" of the pending maintenance cycle is shown inverted. 2. Further use of the machine is not possible if the required maintenance is not carried out and acknowledged now. The procedure for maintenance acknowledgement is explained in chapter: Confirm maintenance. 3. After confirming the maintenance, press the following key: [FEED START] Message is cleared. The menu can be found under: Chapter 2.7 ‘Maintenance cycles’ on page 12