コード 700114: Feed (+) direction disabled

Either an axis has been moved in the area of the centre guard or a movement command has been given to the centre guard area although the pre-conditions for a work area change have not been fulfilled. It is not possible to move the axes in the positive (+) direction. Fulfill the conditions for a change in work area. Observe additionally pending error messages. If both error messages "Movement command (+) and (-) blocked" are shown, a release is only possible in "Step mode". (Key-operated switch "Input“ position [1]. and operating mode [INC 1], [INC 10], [INC 100]). The movable work area centre divider is swivelled to the left, the machine is standing in work area 1 (left) and a movement command X plus ( + ) is output. It is not possible to move the axes in the positive (+) direction. Take the movable working area centre guard to home position. If both error messages "Movement command (+) and (-) blocked" are shown, a release is only possible in "Step mode". (Key-operated switch "Input“ position [1]. and operating mode [INC 1], [INC 10], [INC 100]). Cause 1: Cause 2: On moving the axis away from the end position, an attempt was made to move in the wrong direction. It is not possible to move the axes in the positive (+) direction. Move the corresponding axis away from the end position in minus (-) direction. If both error messages "Movement command (+) and (-) blocked" are shown, a release is only possible in "Step mode". (Key-operated switch "Input“ position [1]. and operating mode [INC 1], [INC 10], [INC 100]).