Code 700127: Pendulum mode 'on' missing

A movable work area centre divider (swivelling/displaceable) has been plugged on the machine but option "Pendulum mode" or "Program number selection" has not been activated. Cause 1: Feed Stop 1. Depending on requirements, activate option "Pendulum mode" or "Program number selection". 2. Press [RESET] key. Message is cleared. Activate one of these options with the work area centre divider in place. In the machining program, the function M261 was output, which monitors whether the corresponding operating state has been activated. Feed Stop, if the corresponding operating state is not activated during a query. 1. Select the required “operating condition“ by pressing the respective key. 2. Check whether the option is set for the corresponding function. 3. Check whether the function was activated in the corresponding menus. 4. Press [FEED START], [RESET] or [Control OFF]. Message is cleared and the machining program can be continued.