コード 701507: Malfunction, oil/air lubrication! Negative pressure vacuum suction nozzle not present

"Oil/air lubrication, vacuum suction nozzle valve on" was actuated, but there was no response from the "Oil/air lubrication, vacuum suction nozzle negative pressure available" sensor within 5 seconds. The early warning of this malfunction was already signalled 100 hours ago, but within this time, the malfunction was not remedied. After the end of the program (M30, work area change), the machine stops. Read disable, Feed Stop and Spindle Stop 1. Check the filter of the oil/air lubrication (contamination). 2. Check the actuation of the "Oil/air lubrication, vacuum suction nozzle valve on" valve. 3. Check the PLC input signal and the "Oil/air lubrication, vacuum suction nozzle negative pressure available" sensor (sensor setting). 4. Check the functionality of the Venturi nozzle for generating negative pressure. 5. As soon as the malfunction is remedied, press the following key: [CYCLE START] Message is cleared. The menu can be found under: Chapter 2.6 ‘Oil/air lubrication’ on page 12 Error messages Oil/air lubrication Malfunction, oil/air lubrication! Negative pressure vacuum suction nozzle not...