コード 701948: Loading not possible from the gate
問題の説明と安全警告
Chiron Siemens-Control CNC は重大な Loading not possible from the gate アラームをトリガーしました。製造サイクル中に機器への二次的損傷や部品の破損を防ぐために、資格のあるオペレーターまたはメンテナンス技術者による直ちの対応が必要です。電気キャビネットにアクセスする前に、必ず標準の安全およびLOTO手順が遵守されていることを確認してください。
公式トラブルシューティング手順
Loading a tool in one of the magazines was started, but the allocation in the tool gate is not yet correct. Tool is in the tool gate, but there is still no data at this place. There is no tool in the tool gate, but there is still data at this place. Tool loading is not started. 1. Cancel the operation with [Reset]. Press the [Stop/Start (Reset)] key for longer than 3 seconds. 2. Check the allocation of the tool gate: Tool present in the tool gate. Data available in the tool management WART2. 3. Restart tool loading. 4. Check the PLC input signal "Tool present in tool gate". The diagnostic overview of the sensor signals can be found under: Chapter 2.2 ‘Tool changer diagnostics menu’ on page 11
Source: CHIRON Error Message Overview, all series (Siemens control, V2.0.6, 2012)
Last reviewed: 2026-07-01 · Verified against the manufacturer’s official documentation.
Chiron Siemens-Control CNC のアラームについて
Chiron によって構築された産業用コントローラーは、内部回路と機械的リンケージを保護するための広範な診断システムで設計されています。Siemens-Control CNC が 701948 のようなエラーコードをスローする場合、通常、指令値と実際のセンサーフィードバック間の不一致を示します。
完全アラーム一覧: 545 Chiron Siemens-Control CNC コードs.
Have a better solution?
Help the industrial community by sharing your repair experience for code 701948.
Need a searchable reference for more Chiron Siemens-Control CNC manuals?
We structure equipment manuals into searchable code, title, cause, solution, safety note, and source-reference data. Send a PDF and example searched codes when you need public pages, private search, or structured exports.
Space reserved for Google AdSense / Industrial Affiliate Links
Monetization target for 2026