代碼 703140: Tool identification system not in working position

The command "Tool identification system to working position" was output, but this is not in the working position. The PLC input signal "Tool identification system, working position" is not registered. Operation is stopped. If the sensor registers in order again within a monitoring time of about 8 seconds, the machine continues on immediately. After the monitoring time has elapsed, the error must be acknowledged. 1. Check sensor and the PLC input signal "Tool identification system, working position". 2. Check actuation and valve "Tool identification system" to working position. 3. As soon as the malfunction has been remedied, press [FEED START] or [CYCLE START]: Message is cleared and the machining program is continued. 4. Switch to NC operating mode "Manual mode". 5. Press [TOOL CH HOME POS.] key. Tool gripper is moved to the home position. The menu can be found under: Chapter 2.2 ‘Tool changer diagnostics menu’ on page 11