コード 750: SPINDLE SERIAL LINK START FAULT
問題の説明と安全警告
Fanuc 16i/18i/21i CNC は重大な SPINDLE SERIAL LINK START FAULT アラームをトリガーしました。製造サイクル中に機器への二次的損傷や部品の破損を防ぐために、資格のあるオペレーターまたはメンテナンス技術者による直ちの対応が必要です。電気キャビネットにアクセスする前に、必ず標準の安全およびLOTO手順が遵守されていることを確認してください。
公式トラブルシューティング手順
This alarm is generated when the spindle control unit is not ready for starting correctly when the power is turned on in the system with the serial spindle. The four reasons can be considered as follows: 1) An improperly connected optic cable, or the spind le control unit’s power is OFF. 2) When the NC power was turned on under alarm conditions other than SU–01 or AL–24 which are shown on the LED display of the spindle control unit. In this case, turn the spindle amplifier power off once and perform startup again. 3) Other reasons (improper combination of hardware) This alarm does not occur after the system includin g the spindle control unit is activated. 4) The second spindle (when SP2, bit 4 of parameter No. 3701, is 1) is in one of the above conditions 1) to 3). See diagnostic display No. 409 for details.
Source: Fanuc Series 16i/18i/21i-B Operator's Manual, Appendix G Alarm List (B-63864EN/03)
Last reviewed: 2026-07-01 · Verified against the manufacturer’s official documentation.
Fanuc 16i/18i/21i CNC のアラームについて
Fanuc によって構築された産業用コントローラーは、内部回路と機械的リンケージを保護するための広範な診断システムで設計されています。16i/18i/21i CNC が 750 のようなエラーコードをスローする場合、通常、指令値と実際のセンサーフィードバック間の不一致を示します。
完全アラーム一覧: 360 Fanuc 16i/18i/21i CNC コードs.
Have a better solution?
Help the industrial community by sharing your repair experience for code 750.
Need a searchable reference for more Fanuc 16i/18i/21i CNC manuals?
We structure equipment manuals into searchable code, title, cause, solution, safety note, and source-reference data. Send a PDF and example searched codes when you need public pages, private search, or structured exports.
Space reserved for Google AdSense / Industrial Affiliate Links
Monetization target for 2026