コード DNET-106: Device not found error
問題の説明と安全警告
Fanuc R-30i Series Robot Controller は重大な Device not found error アラームをトリガーしました。製造サイクル中に機器への二次的損傷や部品の破損を防ぐために、資格のあるオペレーターまたはメンテナンス技術者による直ちの対応が必要です。電気キャビネットにアクセスする前に、必ず標準の安全およびLOTO手順が遵守されていることを確認してください。
公式トラブルシューティング手順
Cause: A device expected to be on the network was not found. Remedy: Check that the device is connected to the network. Check that the device baud rate matches the board baud rate. Reset the device if possible. Cycle power to the controller. If the problem persists, document the events that led to the error and call your local FANUC representative.
Source: FANUC Robot R-30iA Alarm Code List Operator's Manual
Last reviewed: 2026-07-01 · Verified against the manufacturer’s official documentation.
Fanuc R-30i Series Robot Controller のアラームについて
Fanuc によって構築された産業用コントローラーは、内部回路と機械的リンケージを保護するための広範な診断システムで設計されています。R-30i Series Robot Controller が DNET-106 のようなエラーコードをスローする場合、通常、指令値と実際のセンサーフィードバック間の不一致を示します。
Have a better solution?
Help the industrial community by sharing your repair experience for code DNET-106.
Need a searchable reference for more Fanuc R-30i Series Robot Controller manuals?
We structure equipment manuals into searchable code, title, cause, solution, safety note, and source-reference data. Send a PDF and example searched codes when you need public pages, private search, or structured exports.
Space reserved for Google AdSense / Industrial Affiliate Links
Monetization target for 2026