代碼 PRIO-231: EtherNet/IP Adapter Idle
問題描述與安全警告
Fanuc R-30i Series Robot Controller 觸發了嚴重的 EtherNet/IP Adapter Idle 警報。需要由合格的操作員或維修技師立即處理，以防止在製造週期中對設備造成二次損壞或導致零件報廢。在接觸電氣控制箱之前，請務必確保遵循標準安全和停機掛牌 (LOTO) 程序。
官方故障排除步驟
Cause: The robot EtherNet/IP Adapter connection is enabled but no remote scanner has connected to it. Note that it is normal to see this message when the controller first is turned on since the remote scanner (eg. PLC) might not connect to the robot immediately after the robot has been turned on. The PLC will retry the connection again so normally the connection is made shortly after power up. Remedy: Configure the remote scanner (eg. PLC) to connect to the robot. Press RESET to clear alarm. An alarm will be reposted if the connection is still idle.
Source: FANUC Robot R-30iA Alarm Code List Operator's Manual
Last reviewed: 2026-07-01 · Verified against the manufacturer’s official documentation.
關於 Fanuc R-30i Series Robot Controller 警報
由 Fanuc 製造的工業控制器具有廣泛的診斷系統，用於保護內部電路和機械連桿。當 R-30i Series Robot Controller 出現類似 PRIO-231 的錯誤代碼時，通常表示指令值與實際感測器回饋之間存在不匹配。
Have a better solution?
Help the industrial community by sharing your repair experience for code PRIO-231.
Need a searchable reference for more Fanuc R-30i Series Robot Controller manuals?
We structure equipment manuals into searchable code, title, cause, solution, safety note, and source-reference data. Send a PDF and example searched codes when you need public pages, private search, or structured exports.
Space reserved for Google AdSense / Industrial Affiliate Links
Monetization target for 2026