Code SVGN-177: Thk%smm,CloseLim%smm,StdLim%smm

Cause: This is information at pressure shortage. Remedy: Incorrect thickness or/and gun close limit would cause a pressure shortage If thickness or/and gun close limit is incorrect, gun tip can not go correct push depth for setpoint pressure The Thk is value which is specifiied in pressure schedule. Check if thickness value in pressure schedule is correct for actual thickness. This CloseLim is present gun close limit, and the StdLim is gun close limit of no-wear down. If CloseLim is too shorter than StdLim, replace gun tip then perform wear down update program. If StdLim is already too short, set the correct standard limit in servo gun setup screen.