代碼 126-012B: Automatic switchover in simulation mode FullSimul
問題描述與安全警告
Heidenhain TNC Series CNC 觸發了嚴重的 Automatic switchover in simulation mode FullSimul 警報。需要由合格的操作員或維修技師立即處理，以防止在製造週期中對設備造成二次損壞或導致零件報廢。在接觸電氣控制箱之前，請務必確保遵循標準安全和停機掛牌 (LOTO) 程序。
官方故障排除步驟
[Cause of error] The control was automatically switched to the "FullSimul" simulation mode. Possible causes: - Neither a PL nor a machine operating panel was detected in the system. - No devices were detected at the HSCI bus. - The CfgMachineSimul/MP_simMode setting does not match the real hardware components installed. [Error correction] - Check the hardware components - Check the HSCI cable connections - Check the voltage supply to the devices - Note further information in the control's diagnostic functions (bus diagnostics or TNCdiag) - Restart the control. - Set the CfgMachineSimul/simMode setting to "FullSimul" - Inform your service agency [16] 10/2023
Source: HEIDENHAIN NC Error Messages — TNC7/640/620/320/128, CNC PILOT 640, MANUALplus 620 (10/2023)
Last reviewed: 2026-07-01 · Verified against the manufacturer’s official documentation.
關於 Heidenhain TNC Series CNC 警報
由 Heidenhain 製造的工業控制器具有廣泛的診斷系統，用於保護內部電路和機械連桿。當 TNC Series CNC 出現類似 126-012B 的錯誤代碼時，通常表示指令值與實際感測器回饋之間存在不匹配。
完整警報清單: 4497 Heidenhain TNC Series CNC 代碼s.
Have a better solution?
Help the industrial community by sharing your repair experience for code 126-012B.
Need a searchable reference for more Heidenhain TNC Series CNC manuals?
We structure equipment manuals into searchable code, title, cause, solution, safety note, and source-reference data. Send a PDF and example searched codes when you need public pages, private search, or structured exports.
Space reserved for Google AdSense / Industrial Affiliate Links
Monetization target for 2026