Code 140-0052: Installation of setup in PLCE drive failed

[Cause of error] The installation of setup files into the encrypted PLCE drive has failed. [Error correction] Possible causes: - An incorrect password was entered for encrypting the setup file in PLCdesign. Make a new setup.zip file in PLCdesign with the correct password. - A target file name or target directory was entered in PLCdesign that contains illegal characters. Use only ASCII characters for target paths in "PLCE:". Make a new setup.zip file with PLCdesign. - The image file for "PLCE:" is too small for the update. Save the contents of "PLCE:", generate a larger image file, restore the backup and try the update again. - There is no encrypted "PLCE:" partition on the control. Make an encrypted partition and retry the update. - No password was found for the encrypted partition or the incorrect password was entered. Enter a correct password in the settings for the "PLCE:" partition (PLC Programming mode).