コード 231-E019: CC%2 SPLC configuration error ERR-ID=%4

[Cause of error] Alarm ID 1: - Internal software error Alarm ID 2: - Invalid value of machine parameter CfgSafety.inverseInputNoA, CfgSafety.inverseInputNoB, or CfgSafety.testInputNo Alarm ID 3: - The version of the NC software was changed after the safety inspection and acceptance of the machine. - The version of the NC software and the version of the SplcApiMarker.def file being used that is stored in the safety-related machine parameter CfgSafety.splcApiVersion do not match. Alarm ID 4: - Permitted number of SPLC markers (1000/2000) was exceeded. Alarm ID 5: - Permitted number of SPLC DWORDs (1000/3000) was exceeded. Alarm ID 6: - Permitted number of PlcToSPLC transfer markers (64) was exceeded. Alarm ID 7: - Permitted number of PlcToSPLC transfer DWORDs (32) was exceeded. Alarm ID 8: - Marker transfer area PlcToSPLC is faulty. Alarm ID 9: - DWORDs transfer area PlcToSPLC is faulty. [Error correction] Alarm ID 1: - Inform your service agency Alarm ID 2: - Check the values of the machine parameters CfgSafety.inverseInputNoA, CfgSafety.inverseInputNoB, and CfgSafety.testInputNo. Alarm ID 3: - Transfer the 'SplcApiMarker.def' file appropriate to the installed NC software version into the SPLC project. - Enter the value of the constant SPLC_API_VERSION from this file into the safety-related machine parameter CfgSafety.splcApiVersion. - Repeat the safety inspection and acceptance of the machine with the appropriate comprehensiveness. Alarm ID 4: - Check the SPLC program and CfgPlcSafety.splcMarkers Alarm ID 5: - Check the SPLC program and CfgPlcSafety.splcDWords Alarm ID 6 and 8: [526] 10/2023 - Check the SPLC program and CfgPlcSafety.splcMarkersFromPlc[] Alarm ID 7 and 9: - Check the SPLC program and CfgPlcSafety.splcDWordsFromPlc[] 10/2023 [527]