Code 231-E01A: CC%2 FS configuration error ERR-ID=%4 ObjId=%5

Param=%6 [Cause of error] - The transferred configuration data for SKERN are faulty. The ERR ID provides information on the faulty machine parameter: 200 - Machine parameter axisGroup: Assigned axis group out of range 201 - Machine parameter axisGroup: Entered axis group not in use. 202 - Drive type and axis group type do not match. 210 - Permissible number of spindles was exceeded 300 - Machine parameter pwmSignalOutput. Input range exceeded 301 - Machine parameter pwmSignalOutput. The same value was used in two separate entries 400 - Machine parameter timeLimitStop1: Input range exceeded 401 - Machine parameter timeLimitStop2: Input range exceeded 600 - Machine parameter distPerMotorTurn: Input range exceeded 700 - Machine parameter speedLimitSom2, speedLimitSom3, speedLimitSom4, rpmLimitSom2, rpmLimitSom3, rpmLimitSom4: Permissible velocity limit exceeded 800 - An unknown additional function is activated in the config object CfgSafety 810 - Machine parameter timeToEmStopTest: Input range exceeded 820 - Machine parameter watchdogTime: Input range exceeded 900 - Machine parameter brakeAfter: Entered connective operation is not allowed 901 - Machine parameter brakeAfter: A connective operation to yourself is not allowed 1000 - Machine parameters plcCount: PLC / SPLC-MC input range of configured cycle time has been exceeded 1100 - Machine parameters idleState: Configuration of subsequent condition after a stop reaction SS2 is out of the permissible range 1200 - The drive assignment is missing for a safe axis - Faulty parameter values were entered - An internal software error has occurred [Error correction] - Check the ERR ID: 200 - Check the entered value of the axis group 201 - Enter only axis groups that are actually being used 202 - Check the axis group assignment 210 - Check the number of spindles in your system 300 - Check the entity pwmSignalOutput. Input value too large. 301 - Check entity pwmSignalOutput. The same value is in [528] 10/2023 two separate entries. 400 - Check the entered time Parameter value = maximum permissible time 401 - Check the entered time Parameter value = maximum permissible time 600 - Check the entered value 700 - Check the value entered in speedLimitSom for axes, rpmLimitSom for spindles Parameter value = 2 -> SLS_2, Parameter value = 3 -> SLS_3, Parameter value = 4 -> SLS_4 800 - Check the entered additional functions 810 - Check the entered time 820 - Check the entered time 900 - Check the input 901 - Check the input 1000 - Check the input (maximum = 30 ms) 1100 - Check the input 1200 - Check the drive assignment - Inform your service agency.