代码 606-03A0: Finished part no longer located within

%1 [Cause of error] The cycle requires a greater safety clearance in order to work without collision. [Error correction] Program a greater safety clearance. [60C-000B] [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program [60C-000C] [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program [60C-000D] [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program [60C-000E] [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program 10/2023 [1243] [60C-000F] [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program [60C-0010] [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program [60C-0011] [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program [60C-0012] [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program [60C-0013] [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program [1244] 10/2023 [60C-0014] [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program [60C-0015] Actual: %2 Nominal: %3 [Cause of error] The cycle cannot be run with the entered values. [Error correction] - Correct the values - Restart the program [60C-0016] [Cause of error] Automatic calculation of the infeed depths and feed rates is not possible. [Error correction] Vary the number of cuts or set the value to 0 (automatic calculation of the number of cuts) [60F-0033] current workpiece. %1 [Cause of error] An area of the finished part, e.g. an end point, lies outside of the defined workpiece blank. This note has no effect on the program run. [Error correction]