Código 159: CROSS MACHINING IMPOSSIBLE

Type of error: E — NC equipment (system hardware/software error) Stopped status: I — Reset stop Clearing procedure: P — Press reset key Display colour: Red On-screen parameters (shown in parentheses): Alarm No, Cause: Alarm No. Cause 0 × 0001 The specified axis does not exist in the counterpart system. 0 × 0002 The self-system is specified as the system to be cross-controlled. 0 × 0004 The cross machining control is specified for an axis which is already under the control in question. 0 × 0010 A command for cross machining control is given from the counterpart system. 0 × 0040 In the mode of inclined-axis control a cross-control command is given for the fundamental axis (X- axis) without positioning of the inclined axis (Y-axis) in its zero point. In the mode of inclined-axis control a cross-control command is given for the inclined axis (Y-axis). Action: Review and correct the program.