Code M01-0135: Too many active axes per sys

Details High-accuracy control has bee n executed in a part system which has 9 or more enabled control axes, except for a slave or synchronized axis. Remedy  Reduce the number of enabled control axes (except fo r a slave axis and synchronized axis) of the part system to 8 or less through synchronous control, c ontrol axis synchronization between part systems, or mixed control before executing high-accuracy control. Pre-intrpl variable accel err 0136 Details  The parameter "#12060 VblAccPreInt" (Variable-acceleration pre-interpolation acceleration/deceleration ON) is set to "1" and the parameter "#8090 SSS ON" is set to "0". Remedy  To enable the variable acceleration pre-interpolation acceleration/deceleration, set the parameter "#8090 SSS ON" to "1". To disable the variable acceleration pre-interpolation acceleration/deceleration, set the parameter "#12060 VblAccPreInt" to "0". Unable to star t automatic mode 0137 Details  Although start of automatic oper ation is not allowed after a machine groupwise alarm stop ("#1472 mgralmrestart"=0), start of aut omatic operation has been attempted after the said alarm stop.  The cycle operation is started with the guide bushing spindle synchronizati on related spindle is not being set.  The cycle operation is start ed while the "G/B spindle synchronization : temporary cancel" signal is turned ON. Remedy  Remove the cause of the stop by alarm.  Set the parameter "#1472 mgralmrestart" (Allowing au tomatic operation to start after machine groupwise alarm stop) to "1".  Check the parameter "#3074 GBsp".  Turning OFF the "G/B spindle synchronization: tem porary cancel" signal before starting the cycle opera- tion. Tool data sorting in progress 0138 Details Cycle start or graphic check has been attempte d during sorting of tool management data. Remedy  Execute cycle start after the tool data sorting is completed.  Execute graphic check after the tool data sorting is completed. Tolerance control invalid 0139 Details The parameter "#12066 Tolerance ctrl ON" is set to "1", although "#8090 SSS ON" is "0". Remedy  To enable the tolerance control, set "#8090 SSS ON" to "1". To disable the tolerance control, set "#12066 Tolerance ctrl ON" to "0". Ill manualmode select in 3Dcnv 0145 Details The following unselectable manual mode was selected during 3-dimensional coordinate conversion.  manual reference position return Remedy  Cancel the 3-dimensional coordinate conversion modal. Start err in PRM rot manu feed 0146 Details Axis start has been attempted with an y of the following operations while the coordinate rotation by parameter for manual feed is enabled.  Tool retract and return  Manual tool length measurement  Manual skip Remedy  Turn OFF the "Coordinate rotation by parameter: Coordinate switch for manual feed" signal.