コード M01-1014: GB spindle synchro signal OFF

Details  A forward run, reverse run, orientation, synchronous tapping, spindle synchroni zation, tool spindle syn- chronization I, tool spindle synchronization II or C- axis servo ON command was issued to the reference spindle while the guide bushing spindle synchronization signal was OFF.  The guide bushing spindle synchronization signal was turned OFF during a forward run, reverse run, ori- entation, synchronous tapping, spindle synchronization, t ool spindle synchronization I, tool spindle synchro- nization II or C-axis servo ON command.  Orientation was commanded during the "guide bushing spindle synchronization" signal ON with spindle zero point detection with proximit y switch and turret indexing enabled.  C axis servo ON was commanded during the "guide bushing spindle synchronization" signal ON with spin- dle C axis parameter change enabled. Remedy  Check the ladder program.  Check the parameters. GB SP sync:Spindle type error 1015 Details  An analog spindle is used for the master spindle or the guide bushing spindle.  Spindle-mode servo is used for the master spindle or the guide bushing spindle.  Turret gear change control valid spindle is used for the master spindle or the guide bushing spindle. Remedy  Check the parameters.  Change the reference spindle or the guide bushing spindle to spindle drive unit.  Change the reference spindle or the guide bushin g spindle to turret gear change control invalid. GB SP sync:Phase mem sgnl ilgl 1021 Details  The guide bushing spindle synchronization phase memory signal was turned ON while the master spindle or guide bushing spindle was rotating.  The guide bushing spindle synchronization phase memory signal was turned ON while the guide bushing spindle synchronization signal was OFF. Remedy  Check the ladder program. GB SP sync:Phase set sgnl ilgl 1022 Details  The guide bushing spindle synchronization phase alignment signal was turned ON while the master spin- dle or guide bushing spindle was stopped. Remedy  Check the ladder program. GB SP sync:Z phase not pass 1023 Details  When the guide bushing spindle synchronization phase memory signal was ON, the master spindle or guide bushing spindle’s Z-phase was not passed. Remedy  Check the ladder program. Cmnd impsbl in spindle rtry ax 1024 Details Toward the synchronous tapping spindle, the switch to servo-mode is commanded to the spindle-mode rotary axis. The spindle-mode rotary axis in servo-mode is commanded as the synchronous tapping spindle. Remedy Switch to the spindle-mode rotary axis. Other cmnd disabled in orient. 1025 Details  Spindle superimposition control command has been gi ven to an orientation mode spindle with the said spindle treated as either the reference or superimposed spindle.  Orientation command has been given to the reference or superimposed spindle that is under spindle su- perimposition control. Remedy  Cancel the orientation mode.  Use G113 or the "Spindle sync cancel" signal to cancel spindle superimposition.