Code M01-1049: Z detect speed parameter error

Details Phase-Z detection speed has not been set in "#3109 zdetspd". Remedy  Set the phase-Z detection speed in "#3109 zdetspd". Intrf chck across sys: Set err 1050 Details Setting of Interference check ac ross part systems is incorrect. Remedy  Correct the setting of Interfer ence check across part systems. Intrf chck across sys: Area AL 1051 Details Interference is already occurring on the set interfering object. Remedy  Turn OFF the interference check valid signal, moving the axis to a position where the interfering objects do not collide each other, and then rest art Interference check across part systems. Intrf check across sys: Alarm 1052 Details A command has been given that causes the interfering objects to collide each other. Remedy  Correct the program. Interfe chk 0pt return incomp 1053 Details Interference check between part systems had started while ze ro point return of the part system set interfering object has not completed. Remedy  Turn OFF the interference check valid signal, and complete zero point return in the all part systems set interfering object. Feed-forward control disabled 1060 Details Feed-forward control was attempted while any of the following functions was enabled.  Control axis superimposition I/II  Control axis synchronization between part systems I/II Remedy  Turn OFF the feed-forward control request signal. Superimposition axis param err 1070 Details  Cutting feed clamp rate is unspecified for a superimpos ition-related axis. Or the specified rate is outside the setting range. "#2091 plclamp", "#2629 pl3clamp" or "#2630 pl3clamp2"  Rapid traverse rate is unspecified for a superimposition-related axis. Or the specified rate is outside the setting range. "#2090 plrapid", "#2621 plrapid2", "#2626 pl3rapid", "#2627 pl3rapid2" or "#2628 pl3rapid3" Remedy  Set the cutting feed clamp rate of the superim position-related axis within the setting range.  Set the rapid traverse rate of the superimpo sition-related axis within the setting range.