Code M01-1255: Multiple secondary ax selected

Details For the multiple axis synchronization control, you selected two or more slave axes without selecting any master axis. Remedy Correct the setting of R2589 (Synchronous control operation method selection). Cmnd invalid during VCC mode 1300 Details The issued command is disabled during the vibration cutting mode. Remedy Correct the program. VCC mode command invalid 1301 Details Vibration cutting mode start command has been issued although the command is disabled during the currently active mode. Remedy Correct the program. VCC invalid 1302 Error cause number Details [When error cause No. is 0001] Cutting is being performed without vibration cutting control. [When error cause No. is 0002] Vibration cutting is being performed with OMR-FF being disabled. Remedy [When error cause No. is 0001] Make sure that the "VCC: Temporary cancelof axis vibration" signal (R22532) is OFF. Make sure that the spindle speed command isnot "0" when the cutting command is issued. Make sure that neither synchronized axis nor superimposed axisis included in the part system. [When error cause No. is 0002] Make sure that the servo parameter "#2313 SV113" bit0is "1" and bit1 is "0" for the VCC objective axes. Feedrate limited during VCC 1303 Details The feedrate command issued during the vibration cutting mode is exceeding "#12571 VibClamp_VCC". Remedy Correct the program. VCC condition not found 1304 Details No applicable condition is found during theselection of the vibration cutting condition. Remedy Correct the program. Check the setting of the frequency upper limit "#12131 FrqClmpSys_VCC". Check the settings of the maximum spindle rotationspeed "#3005 smax1" to "#3008 smax4" and the min- imum rotation speed "#3023 smini". Cannot change SP speed in VCC 1307 Details You changed the spindle rotation speed during vibration cutting control. Remedy Wait for completion of vibration cutting control, or input Reset to cancel the VCC mode. Cannot re-runSP during VCC 1308 Details You stopped the spindle during vibration cutting control, and then attempted to re-run it. Remedy If you have stopped the spindle during vibration cuttingcontrol, input Reset to cancel the VCC mode before re-running the spindle.