代码 S53-101: Safety Function Warnings
问题描述与安全警告
Mitsubishi M800/M80 CNC 触发了严重的 Safety Function Warnings 警报。需要由合格的操作员或维修技师立即处理，以防止在制造周期中对设备造成二次损坏或导致零件报废。在接触电气控制箱之前，请务必确保遵循标准安全和停机挂牌 (LOTO) 程序。
官方故障排除步骤
The contactor shutoff test is being executed. Remedy The emergency stop is reset automatically after the contac tor shutoff is confirmed. If the contactor shutoff is not confirmed within 5 seconds after the "contactor shut off test" signal has been input, the "contactor welding detected" alarm o ccurs and the emergency st op status remains. Make sure that the contactor's auxil iary b contact signal is correctly output to the device that is set in "#1330 MC_dp1" and "#1331 MC_dp2" (Contactor weld detection device 1 and 2), and then turn the power ON again. Emergency stop IPWD
Source: Mitsubishi M800/M80/E80 Series Alarm/Parameter Manual (IB-1501279)
Last reviewed: 2026-07-01 · Verified against the manufacturer’s official documentation.
关于 Mitsubishi M800/M80 CNC 警报
由 Mitsubishi 制造的工业控制器具有广泛的诊断系统，用于保护内部电路和机械连杆。当 M800/M80 CNC 出现类似 S53-101 的错误代码时，通常表示指令值与实际传感器反馈之间存在不匹配。
完整报警清单: 722 Mitsubishi M800/M80 CNC 代码s.
Have a better solution?
Help the industrial community by sharing your repair experience for code S53-101.
Need a searchable reference for more Mitsubishi M800/M80 CNC manuals?
We structure equipment manuals into searchable code, title, cause, solution, safety note, and source-reference data. Send a PDF and example searched codes when you need public pages, private search, or structured exports.
Space reserved for Google AdSense / Industrial Affiliate Links
Monetization target for 2026