代碼 T01-0107: No operation mode

Details The operation mode has not been selected. Remedy  Select automatic operation mode.  Check for any broken wires in the signal line for automatic operation mode (memory, tape, MDl). Operation mode duplicated 0108 Details Two or more automatic operation modes have been selected. Remedy  Check for any short circuit in the mode (memory, tape, MDl) selection signal line.  Check for any failure in the switch.  Correct the sequence program. Operation mode changed 0109 Details The automatic operation mode has changed to another automatic operation mode. Remedy  Return to the original automatic opera tion mode, and execut e automatic start. Tape search execution 0110 Details Automatic start is not possible as tape search is being executed. Remedy  Wait for the tape search to be comple ted and then execute the automatic start. Cycle start prohibit 0111 Details Automatic start is disabled because restart search is in execution. Remedy  Execute automatic start after t he restart search is completed. CNC overheat 0113 Details Automatic start is not possible because a thermal alarm (Z53 CNC overheat) has occurred. Remedy  Temperature of the control unit ha s exceeded the specified temperature.  Take appropriate measures to cool the unit. Cycle st. prohibit(Host comm.) 0115 Details Automatic start cannot is not possible because th e NC is communicating with the host computer. Remedy  Wait for the communication with host computer to be ended and then execute the automatic start. Cycle st prohibit(Battery alm) 0116 Details Automatic start is not po ssible because the voltage of the batter y in the NC control unit has dropped. Remedy  Replace the battery of the NC control unit.  Contact the service center. R-pnt offset value not set 0117 Details Automatic operation is not possible because no reference position offset value has been set. Remedy  Perform the reference position initialization setting, then set "#2034 rfpofs(Distance-coded reference po- sition detection offset)".