Code T01-0147: Mach. interrupt non-startable

Details Machining interruption related fu nctions cannot be started up. Remedy  To resume the operation from the state of being st opped at the selected point, set the automatic operation mode to the memory mode.  To perform the retraction, confirm that retraction is enabled (the "Retraction executable" signal is ON).  To resume the operation from the state of being stopped at a certain block of the retraction program, acti- vate the memory mode and turn ON the "Retraction start" signal.  Check the sequence program to make sure that multip le start signals are not input at the same time. (Note) The remedies stated above apply not only to retr action but also to the other machining interruption-re- lated functions. (The start signals and ready st ates are replaced with th ose for each function.)