代碼 10750: [Channel %1: ] Block %2 tool radius compensation activated without tool number

Parameters: %1 = Channel number %2 = Block number, label Diagnostics Manual (DAsl), 03/2009 Definitions: A tool T... must be selected so that the control can make allowance for the associated compensation values. A correction data block (D1) containing the correction values (parameter P1 - P25) is automatically assigned to each tool (T number). Up to 9 correc tion data blocks can be assi gned to a tool by specifying the required data block with the D number (D1 - D9). The cutter radius compensation (CRC) is allowed fo r if function G41 or G42 is programmed. The correction values are contained in parameter P6 (geomet ry value) and P15 (wear value) of the active correction data block Dx. Reaction: Correction block is reorganized. Interpreter stop Local alarm reaction. Interface signals are set. Alarm display. Remedy: Before calling the CRC with G41/G42, program a tool number under the address T... Program Continuation: Clear alarm with NC ST ART or RESET key and continue the program.