コード 10795: [Channel %1: ] Block %2 end point specification during angle programming contradictory

Parameters: %1 = Channel number %2 = Block number, label Definitions: During programming of a straight line, both positi ons of the active plane and an angle were specified (the position of the end point is over-specified), or the position of the programmed coordinate cannot be reached with the specified angle. If a contour consisting of two stra ight lines is to be programmed with angles, it is possible to specify the two ax is positions of the plane and an angle in the second block. The error can also occur if, due to a pr ogramming error, the preceding block cannot be interpreted as the first subblock of such a contour. A bloc k is interpreted as the first block of a two-block contour if an angle, but not an axis of the active plane, was programmed, and if the block is not already the second block of a contour. Reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end. Remedy: Modify part program. Program Continuation: Clear alarm with NC ST ART or RESET key and continue the program.