代碼 14016: [Channel %1: ] Block %2 error when calling the subroutine via M/T function

Parameters: %1 = Channel number %2 = Block number, label Definitions: The following conflict was detected in a subprogram call per M or T function: In the block referenced by parameter %2: - An M or T function replacem ent has already been activated - A modal subprogram call is active - A subprogram return jump is programmed - An end of program is programmed - An M98 subprogram call is acti ve (only in external language mode) - T function replacement by D function programming in the same part program line is not possible with active TLC (G43/G44) in ISO2 system. Reaction: Correction block is reorganized. Interface signals are set. Alarm display. Remedy: An M or T function replacement is only possible if a subprogram call or return jump has not already been performed as a result of other program constructs. The part program must be corrected accordingly. Program Continuation: Clear alarm with NC ST ART or RESET key and continue the program. Diagnostics Manual (DAsl), 03/2009