代碼 14092: [Channel %1: ] Block %2 axis %3 is wrong axis type

Parameters: %1 = Channel number %2 = Block number, label %3 = Axis name, spindle number Definitions: One of the following progr amming errors has occurred: 1. The keyword WAITP(x) "Wait with block change unt il the specified positi oning axis has reached its end point" has been used for an axis that is not a positioning axis. 2. G74 "Reference point approach from the program " has been programmed for a spindle. (Only axis addresses are permitted). 3. The keyword POS/POSA has been used for a spindle. (The keywords SPOS and SPOSA must be programmed for spindle positioning). 4. If the alarm occurs with the "Rigid tapping" function (G331), the followin g causes are conceivable: - The master spindle is not in position-controlled mode. - Incorrect master spindle - Master spindle without encoder 5. An axis name was programmed which no longer exists (e.g. when using axial variables as an index). Or NO_AXIS has been programmed as an index. 6. If 14092 is output as a note with alarm 2 0140 Motion-synchronous action: traversing of command axis, the following causes are possible: - The axis is currently being trav ersed by the NC program already. - An overlaid movement is active for the axis. - The axis is active as fo llowing axis of a coupling. - An interpolation compensation such as a tem perature compensation is active for the axis. Reaction: Correction block is reorganized. Interface signals are set. Alarm display. Remedy: - Correct the part program according to which of the above errors is involved. - Program SPOS. - Set the correct master spindle with SETMS. Program Continuation: Clear alarm with NC ST ART or RESET key and continue the program.