Code 14549: [Channel %1: ] Block %2 contour tool: impermissible programming. Code no. %3

Parameters: %1 = Channel number %2 = Block number, label %3 = Error code Diagnostics Manual (DAsl), 03/2009 Definitions: Impermissible programming has been found for contour tools on active tool r adius compensation. The error cause is explained in detail by the error code. 1: In G code group 17, KONT is active during activation 2: In G code group 17, KONT is active during deactivation 9: In G code group 40, CUTCONOF is not active 10: Reprogramming of G41 / G42 in already ac tive tool radius compensation not permissible 20: Circle with more than one rotation not permissible 21: Ellipse (circle not in compensation level) 23: Involute not permissible 24: Several polynomials not permitted in one block only. These blocks coul d be created by e.g. COMPCAD or G643. 30: Preprocessing stop not permitted 41: Starting point of first compensation bloc k cannot be reached by anyone of the defined cutting edges 42: End point of last compensation block c annot be reached by anyone of the defined cutting edges Reaction: Correction block is reorganized. Local alarm reaction. Interface signals are set. Alarm display. NC Stop on alarm at block end. Remedy: Change NC program. Program Continuation: Clear alarm with NC ST ART or RESET key and continue the program.