代碼 14823: [Channel %1: ] Block %2 error on selection or deselection of tool monitoring

Parameters: %1 = Channel number %2 = Block number, label Definitions: On selecting tool monitoring with TMON, one of the following errors occurred: - Selection does not refer to a grinding-specific tool (400-499). - Selection refers to an invalid spindle number. - An attempt has been made to select tool monitori ng for a spindle that is already assigned to another tool by TMON, GWPSON, CLGON or ac tivation of tool length compensation. - An attempt has been made to select a tool that has not been defined. - An attempt has been made to select an edge (implicitely) that has not been defined. (Implicit selection: D1 of a tool, if no edge has been specified.) - An attempt has been made to select tool monitoring for the active tool, although no tool length compensation has been activated. - Invalid parameter number for radius calculation in $TC_TPG9. The following values are valid: 3 for $TC_DP3 (length 1) 4 for $TC_DP4 (length 2) 5 for $TC_DP5 (length 3) 6 for $TC_DP6 (radius) A grinding wheel radius equal to zero has been specified. On deselecting tool monito ring with TMOF, one of the following errors occurred: - Deselection does not refer to a grinding-specific tool (400-499). - An attempt has been made to deselect tool monitori ng for the active tool, although tool length compensation is not active. - Deselection refers to an invalid spindle number. Reaction: Correction block is reorganized. Interface signals are set. Alarm display. Remedy: Check TMON and TMOF command. Check tool compensation data. - $TC_DP1: 400 - 499. - $TC_TPG1: Spindle number. - $TC_TPG8: Inclination angl e for slope grinding wheel. - $TC_TPG9: Parameter number for radius computation, e.g. 3 for $TC_GP3. Program Continuation: Clear alarm with NC ST ART or RESET key and continue the program.