コード 17193: [Channel %1: ] Block %2 the acti ve tool is no longer on toolholder no./spindle no. %3, program %4

Parameters: %1 = Channel number %2 = Block number, label %3 = Toolholder no., spindle no. %4 = Program name Definitions: The tool at the specified toolhol der/spindle at which the last tool change was carried out as master toolholder or master spindle, has been replaced. Example: N10 SETHTH(1) N20 T="Wz1"; Tool change at master toolholder 1 N30 SETMTH(2) N40 T1="Wz2"; Toolholder 1 is only a secondary toolholder. Changing the tool does not resu lt in correction deselection. N50 D5; New correction selection. At present, there is no active tool which D can refer to, i.e. D5 refers to T no. = 0, which results in zero correction. Reaction: Interface signals are set. Alarm display. Remedy: - Modify program: - Set desired spindle as master spindl e or toolholder as master toolholder. - Then, if required, reset master spindle or master toolholder. Program Continuation: Clear alarm with the Delete key or NC START.