Code 201005: <location>Firmware download for DRIVE-CLiQ component unsuccessful

Message value: Component number: %1, fault cause: %2 Drive object: All objects Reaction: NONE Acknowledge: IMMEDIATELY Cause: It was not possible to download the firmware to a DRIVE-CLiQ component. Fault value (r0949, interpret hexadecimal): yyxxxx hex: yy = component number, xxxx = fault cause xxxx = 000B hex = 11 dec: DRIVE-CLiQ component has detected a checksum error. xxxx = 000F hex = 15 dec: The selected DRIVE-CLiQ component did not accept the contents of the firmware file. xxxx = 0012 hex = 18 dec: Firmware version is too old and is not accepted by the component. xxxx = 0013 hex = 19 dec: Firmware version is not suitable for the hardware release of the component. xxxx = 0065 hex = 101 dec: After several communication attempts, no response from the DRIVE-CLiQ component. xxxx = 008B hex = 139 dec: Initially, a new boot loader is loaded (must be repeated after POWER ON). xxxx = 008C hex = 140 dec: Firmware file for the DRIVE-CLiQ component not available on the memory card. xxxx = 008F hex = 143 dec: Component has not changed to the mode for firmwa re download. It was not possible to delete the existing firmware. xxxx = 0090 hex = 144 dec: When checking the loaded firmware (checksum) the com ponent identified an error. It is possible that the file on the memory card is defective. xxxx = 0091 hex = 145 dec: Checking the loaded firmware (checksum) was not completed by the component in the appropriate time. xxxx = 009C hex = 156 dec: Component with the specified componen t number is not available (p7828). xxxx = Additional values: Only for internal Siemens troubleshooting. Remedy: - check the selected component number (p7828). - check the DRIVE-CLiQ connection. - save suitable firmware file for download in the directory /siem ens/sinamics/code/sac/. - after POWER ON has been carried out again fo r the DRIVE-CLiQ component, download the firmware again. Depending on p7826, the firmware will be automatically downloaded.