コード 22035: [Channel %1: ] Block %2 following axis/spindle %3 unable to determine the offset value (reason %4).

Parameters: %1 = Channel number %2 = Block number, label %3 = Following axis/spindle number %4 = Reason Definitions: The determination of the override value ($AA_CO UP_CORR[Sn]) intended by the NC/PLC signal DB31,... DBX31.6 (Correct synchronism) cannot be executed. The override value cannot be calculated properly. The reasons for this may be: - Reason 1: The following axis is not configured as a spindle. - Reason 2: The coupling has mo re than one active leading axis. - Reason 3: The leading axis is not configured as a spindle. - Reason 4: The coupling factor is neither 1 nor -1 (the quotient from CPLNUM and CPLDEN). - Reason 5: CPLSETVAL = "cmdvel". - Reason 6: An independent motion component of the fo llowing spindle is active (VDI interface signal DB31.., DBX98.4 = 1). - Reason 7: There is no following spi ndle synchronism on the setpoint side. - Reason 8: The synchronism on the setpoint side has decreased again. Reaction: Alarm display. Remedy: The following remedies are available for the indicated reasons: - Reasons 1 to 5: The coupling has to be reconfigured/reprogrammed. - Reasons 6 and 7: Wait until VDI interface si gnals DB31.., DBX99.4 'Synchronization running' = 0 and DB31.., DBX98.4 'Overlaid movement' = 0 bef ore setting VDI interface signal DB31..,DBX31.6 'Correct synchronism'. - Reason 8: Wait until the following axle/spindle c an follow the leading values before setting VDI interface signal DB31.., DBX31.6 'Correct synchronism'. Program Continuation: Clear alarm with the Delete key or NC START.