Code 22100: [Channel %1: ] Block %3 spindle %2 chuck speed exceeded

Parameters: %1 = Channel number %2 = Axis name, spindle number %3 = Block number, label Definitions: The actual spindle speed is higher than the maximum speed configured in MD35100 $MA_SPIND_VELO_LIMIT plus a tolerance of 10 percent (fixed setting). The alarm should not occur after correct optimization of the driv e actuator and gear configuration. This alarm can be reconfigured with MD11412 $MN_ALARM_REACTION_CHAN_NOREADY (channel not ready to operate) to 'BAG not ready'. Note: Reconfiguring affects all alarms with alarm response 'Chan not ready'. Reaction: Mode group not ready. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. Channel not ready. Remedy: Please inform the authorized personnel/service department. Check the setup and optimization data of the drive actuator in accordance with the In stallation and Start-up Guide and make corrections. Increase the tolerance window in MD35150 $MA_SPIND_DES_VELO_TOL. Program Continuation: Clear alarm with the RESET key in all channel s of this mode group. Restart part program.