コード 25020: Axis %1 zero mark monitoring of active encoder

Parameters: %1 = Axis name, spindle number Definitions: For PROFIdrive: The position encoder pulses between 2 zero mark pu lses are counted, and the plausibility is assessed (The functionality and possibly the par ameteritation of the plausibility check is done on the drive side. Please refer to the relevant drive documentation fo r details.), and reported in a PROFIdrive message frame (encoder interface) to the control, which then issues the present alarm. The alarm can be reprogrammed in MD11412 $MN_ALARM_REACTION_CHAN_NOREADY (channel not ready). Reaction: Mode group not ready. The NC switches to follow-up mode. Channel not ready. NC Start disable in this channel. Axes of this channel must be re-referenced. Interface signals are set. Alarm display. NC Stop on alarm. Channel not ready. Remedy: Please inform the authorized personnel/service department. The differences can result from transmission erro rs, disturbances, encoder har dware faults or from the evaluation electronics in the encoder used for position control. Th e actual value branch must therefore be checked: 1. Transmission path: Check the ac tual-value connectors for corr ect contacting, encoder cable for continuity, and also check for shor t-circuits and groundi ng (loose contact?). 2. Encoder pulses: Is the encoder power supply within the tolerance limits? 3. Evaluation electronics: Replace or rec onfigure the drive or encoder module used. Monitoring can be switched off by setting MD36310 $MA_ENC_ZERO_MONITORING [n] to 0 or 100 (n = encoder number: 1, 2). Program Continuation: Clear alarm with the RESET key in all channel s of this mode group. Restart part program.