コード 27005: Axis %1 error in data cross check: static actual value difference

Parameters: %1 = Axis number Definitions: Via the data cross check between NCK and SIMO DRIVE611D monitoring channel, a difference in actual values was detected, which is great er than the maximum tolerance defined in MD $MA_SAFE_POS_TOL. This can be checked by means of the safe position values for the two monitoring channels displayed in the service menu. The alarm is displayed only, if monitoring with absolute reference (SE/SN) has been enabled for the specified axis and if the user enab le has been set. The alarm is cleared, as soon as the user enable is deleted or the actual value difference between the two monitoring channels falls again below the maximum permissible difference. Reaction: Alarm display. Remedy: If the alarm is present statically, the user enable must be deleted. When the control is then rebooted, the machine can be brought to the safe state again and operation resumed by a new referencing process and setting of the user enable. Prior to setti ng the user enable, the actual position of the axis displayed in the "User enable" screen must be compar ed with the current machine position. This is obligatory to ensure the proper functioning of the safe limit positions (SE) and safe cams (SN). A change of the user acknowledgement is only possible with key switch position 3 or after input of a password. Program Continuation: Alarm display showing cause of alarm disapp ears. No further operator action necessary.