コード 27257: PROFIsafe: %1 %2 re ports system error %3 (%4)

Parameters: %1 = Type of communication %2 = PROFIsafe address %3 = Error code %4 = Component Definitions: A system error has been detected in the PROFIsafe communication. Depending on the error, the relevant PROFIsafe driver or the entire PROFIsafe communication will be stopped. In %1 the communication type is displayed %1 = F module %1 = SPL %2 = PROFIsafe address of the affected F module (with %1 = F module) %2 = - (with %1 = SPL) In %3 the detected error cause is displayed: %3 = SF: Asynchronous error state (StateFault) %3 = SP: No update of the SPL input/output data (SPL I/O communication) In %4 the affected component is displayed: %4 = NCK %4 = PLC Reaction: Mode group not ready. Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. NC Stop on alarm. STOP D/E (settable via MD $MN_SPL_STOP_MODE) triggered on all axes wi th safety functionality. Stop of the affected PROFIsafe drivers. Stopped PROFIsafe drivers of F modules of type F-DI or FDIO output failsafe values (0) as F user data to the SPL. Remedy: Power OFF/ON of the control. If the error occurs again, inform the service department. Diagnostics Manual (DAsl), 03/2009 Program Continuation: Switch control OFF - ON.