コード 380003: PROFIBUS/PROFINET: Operating erro r, reason %1 parameter %2 %3 %4.

Parameters: %1 = Cause of the error %2 = Parameter 1 %3 = Parameter 2 %4 = Parameter 3 Definitions: An operating error occurred on the PROFIBUS/PROFINET in cyclic mode. Overview: Cause of the error, Par 1, Par 2, Par 3: - 01 = unknown alarm, alarm class, logical address, -- 02 = DPM cycle timeout, DPM actual val ue status, DPM setpoint value status, -- 03 = DPM cycle status, DPM actual value status, DPM setpoint value status, DPM error code - 04 = DPM cycle error, DPM actual value stat us, DPM setpoint value status, DPM error code - 05 = Client not registered, client number, max. number of clients, -- 06 = Synchronisation error, number of sync violation, --, -- 07 = Spinlock timeout, PLC spinlock, NCK spinlock, -- 1000s digit of the error cause = number of the affected bus Alarm class: (see alarm 380 060) The following can be primary causes: - For error cause 01: Data transfer error on the PROFIBUS/PROFINET - For error causes 02, 03, 04: Error in contents of SDB - For error causes 02, 03, 04, 05, 07: Corruption of parts of system program - For error cause 06: The PCI bus cycle does not match the expected rate, so synchronization is not possible. The correct PCI bus cycle must be entered. The error can also be caused by a hardware problem on the MCI module. Reaction: Channel not ready. NC Start disable in this channel. Interface signals are set. Alarm display. Remedy: - For error cause 01: - Check the electrical and fault -related specifications for PROFIB US/PROFINET, assess the cable installation - Check the terminating resistors of the PROFIBUS connectors (ON setting at ends of cables, otherwise OFF setting required) - Check slave/device - For error causes 02, 03, 04: - Check SDB - For error causes 02, 03, 04, 05, 07: - Follow the procedure described for troubleshooting alarm 380 001 - For error cause 06: - The correct PCI bus cycle must be entered. If the error cannot be eliminated by this procedure, send the error text to the control system manufacturer. Program Continuation: Clear alarm with the RESET key. Restart part program