コード 4345: [Channel %1: ] Invalid configuration in chained transformation no. %2

Parameters: %1 = Channel number %2 = Transformation number Definitions: A chained transformation is incorrectly co nfigured (MD24995 $MC_TRACON_CHAIN_1 or MD24996 $MC_TRACON_CHAIN_2). The following causes for the error are possible: - The list of transformations to be chained starts wi th a 0 (at least one entry not equal to zero is required). - The list of transformations to be chained contai ns the number of a transformation which does not exist. - The number of a transformation in the list is great er than or equal to the number of the chained transformation. Example: The cascaded transformation is the fourth transformation in the system, i.e. MD24400 $MC_TRAFO_TYPE_4 = 8192. In this case, only values 1, 2 or 3 may be entered in the associated list (e.g. MD24995 $MC_TRACON_CHAIN_1[...]). - The chaining setting is invalid. The following rest rictions currently apply. A maximum of two transformations can be chained. The firs t transformation must be an orientation transformation, transmit, peripheral curve transformation or inclined axis. The second transform ation must be the inclined axis transformation. Reaction: Correction block is reorganized. Interface signals are set. Alarm display. NC Stop on alarm at block end. Remedy: Set a valid transformation chain. Program Continuation: Clear alarm with the RESET key. Restart part program