コード 6431: [Channel %1: ] Block %2 Function not allowed. Tool management/monitoring is not active.

Parameters: %1 = Channel ID %2 = Block number, label Definitions: Occurs when a data management function is called which is not available because ToolMan is deactivated. For example, the language commands GETT, SETPIECE, GETSELT, NEWT, DELT. Reaction: Correction block is reorganized. Interface signals are set. Alarm display. Remedy: - Please inform the authorized personnel/service department. - Make sure of how the NC is supposed to be co nfigured! Is tool management or tool monitoring needed but not activated? - Are you using a part program that is meant for a numerical control with tool management/tool monitoring? It is not possible to start this program on the numerical control wi thout tool management/tool monitoring. Either run the part program on the appropriate NC control or edit the part program. - Activate tool management/tool monitoring by setting the appropriate machine data. See MD18080$MN_MM_TOOL_MANAGEMENT_MASK, MD20310$MC_TOOL_MANAGEMENT_MASK - Check whether the required option is set accordingly. Program Continuation: Clear alarm with NC ST ART or RESET key and continue the program.