コード 75016: [Channel %1: ] CLC: block %2 orientation changed for TRAFOOF

Parameters: %1 = Channel number %2 = Block number Definitions: 1. The 2D/3D clearance control has been switched of f before the transformation. The tool direction according to G17/G18/G19 has been applied as the c ontrol direction. Switching on the transformation with rotary axis settings that define a different to ol orientation requires an orientation step change and is therefore rejected. 2. The transformation has been switched off temporar ily (TRAFOOF) while clearance control is still active. When the transformation is switched on again, the tool orientation must be the same as when it was switched off, i.e. the rotary axes must not be moved while the transformation is deactivated. Reaction: NC Start disable in this channel. Alarm display. NC Stop on alarm. Remedy: Modify part program: Do not switch on the clearance control until the transform ation is already active or make sure that the required conditi ons relating to orientation are observed. Program Continuation: Clear alarm with the RESET key. Restart part program