コード oPE05: Run Command/Frequency Reference Source Selection Error

Code type: Operator programming error Manual section: Yaskawa A1000 Troubleshooting Frequency reference is assigned to an option card (b1-01 = 3) but an input option card is not connected to the drive. Reconnect the input option card to the drive. The Run command is assigned to an option card (b1-02 = 3) but an input option card is not connected to the drive. Frequency reference is assigned to the pulse train input (b1-01 = 4), but terminal RP is not set for frequency reference input (H6-01 > 0) Set H6-01 to “0”. Although the digital card input is set for BCD special for a 5 digit input (F3-01 = 6), the data length is set for 8 bit or 12 bit (F3-03 = 0, 1). Set the input data for 16 bit (F3-03 = 2). The following values have been set while an AI-A3 option card is installed: - The source of frequency reference setting is assigned to an option card (b1-01 = 3). - The action for the analog card is set for separate terminal input (F2-01 = 0). Make sure parameters are set properly.