Code oPE08: Parameter Selection Error

Code type: Operator programming error Manual section: Yaskawa A1000 Troubleshooting Attempted to use a function that is not valid for the selected control mode. Check the motor control method and the functions available. In Open Loop Vector Control, n2-02 is greater than n2-03 Correct parameter settings so that n2-02 is less than n2-03. In Open Loop Vector Control, C4-02 is greater than C4-06 Correct parameter settings so that C4-02 is less than C4-06. In OLV/PM, parameters E5-02 to E5-07 are set to 0. - Set the correct motor code in accordance with the motor being used (E5-01). - When using a special-purpose motor, set E5-□□ in accordance with the test report provided. Both E5-09 and E5-24 are set to 0, or are not 0 in control modes for PM. Set E5-09 or E5-24 to the correct value, and set the other to “0”. In AOLV/PM High Frequency Injection is disabled (n8-57 = 0) and the minimum frequency (E1-09) is set lower than 1/20 of the base frequency setting. Correct the parameter settings. Or, set n8-57 to 1 to enable High Frequency Injection. Note: Use U1-18 to find which parameters are set outside the specified setting range. Other errors are given precedence over oPE08 when multiple errors occur at the same time.