Código 700016: Control cabinet cooler malfunction

Thermal contact in the control cabinet cooler has responded. The PLC input signal "Control cabinet cooler malfunction" is not registered. The error has the following effect as soon as the end of the machining program has been reached: Feed Stop No axis movements possible. "Spindle Stop" Tool spindle is stopped. Speed no longer possible. For MT series: Channel-specific "Read-in stop" after pulling bar call ( M450 ) or workpiece counting pulse ( M60 ) on this channel. The other channel, respectively, continues to run until the next tool change or rapid feed ( G0 ). 1. Check electric cabinet cooler actuation. 2. Check the thermal contact and PLC input signal "Control cabinet cooler malfunction". 3. Press [FEED START]. Machining program is continued until the next end of program. If needed, the program can be continued by acknowledging the error with the key [CYCLE START] (but only until the next end of program). The operator will be reminded of this at every end of program. Malfunction can be remedied at an appropriate point in time.