代碼 700100: Fine filter air purge dirty (1)
問題描述與安全警告
Chiron Siemens-Control CNC 觸發了嚴重的 Fine filter air purge dirty (1) 警報。需要由合格的操作員或維修技師立即處理，以防止在製造週期中對設備造成二次損壞或導致零件報廢。在接觸電氣控制箱之前，請務必確保遵循標準安全和停機掛牌 (LOTO) 程序。
官方故障排除步驟
Differential pressure switch for the air purge filter monitoring has triggered. Feed Stop after end of program (Program end with M02, M30 or change work area / table side) 1. Replace air purge filter. 2. Check differential pressure switch and input. 3. Once the malfunction has been remedied, press [FEED START]. Message is cleared. If needed, the program can be continued by acknowledging the error with the key [CYCLE START] (but only until the next end of program). The operator will be reminded of this at every end of program. Malfunction can be remedied at an appropriate point in time.
Source: CHIRON Error Message Overview, all series (Siemens control, V2.0.6, 2012)
Last reviewed: 2026-07-01 · Verified against the manufacturer’s official documentation.
關於 Chiron Siemens-Control CNC 警報
由 Chiron 製造的工業控制器具有廣泛的診斷系統，用於保護內部電路和機械連桿。當 Siemens-Control CNC 出現類似 700100 的錯誤代碼時，通常表示指令值與實際感測器回饋之間存在不匹配。
完整警報清單: 545 Chiron Siemens-Control CNC 代碼s.
Have a better solution?
Help the industrial community by sharing your repair experience for code 700100.
Need a searchable reference for more Chiron Siemens-Control CNC manuals?
We structure equipment manuals into searchable code, title, cause, solution, safety note, and source-reference data. Send a PDF and example searched codes when you need public pages, private search, or structured exports.
Space reserved for Google AdSense / Industrial Affiliate Links
Monetization target for 2026