Código 700115: Feed (-) direction disabled

Either an axis has been moved in the area of the centre guard or a movement command has been given to the centre guard area although the pre-conditions for a work area change have not been fulfilled. No movement of the axes in minus (-) direction is possible. Fulfill the conditions for a change in work area. Observe additionally pending error messages. If both error messages "Movement command (+) and (-) blocked" are shown, a release is only possible in "Step mode". (Key-operated switch "Input“ position [1]. and operating mode [INC 1], [INC 10], [INC 100]). Cause 3: Cause 1: Error messages General Feed (-) direction disabled The movable working area centre guard is swivelled to the right, the machine is standing in work area 2 (right) and a movement command X minus is output. No movement of the axes in minus (-) direction is possible. Take the movable working area centre guard to home position. If both error messages "Movement command (+) and (-) blocked" are shown, a release is only possible in "Step mode". (Key-operated switch "Input“ position [1]. and operating mode [INC 1], [INC 10], [INC 100]). On moving the axis away from the end position, an attempt was made to move in the wrong direction. No movement of the axes in minus (-) direction is possible. Move the corresponding axis away from the end position in plus (+) direction. If both error messages "Movement command (+) and (-) blocked" are shown, a release is only possible in "Step mode". (Key-operated switch "Input“ position [1]. and operating mode [INC 1], [INC 10], [INC 100]). Cause 2: Cause 3: