Código 700135: Mist collector not selected

In the machining program, the function M265 is output, which monitors whether the exhaust fan is activated. Feed Stop 1. Select the required “operating condition“ by pressing the respective key. 2. Check whether the option is set for the corresponding function. 3. Once the malfunction has been remedied, press [FEED START] key. Message is cleared and the machining program can be continued. These messages will appear immediately after output of the Mfunction, even when the respective option has been deactivated (PLC – machine data). In automatic mode, the "coolant" or "minimal lubrication" was activated, but the "exhaust fan“ is not switched on. Cause 1: Cause 2: Error messages Suction system Mist collector not selected Machining with oil: Machining stop when traversing in rapid feed [G0]. (Spindle Stop/Feed Stop and coolant off). Machining with water: Machining stop after program end. (Spindle Stop/Feed Stop and coolant off). (Program end with M02, M30 or change work area / table side) 1. Switch on the exhaust fan. 2. Press [FEED START] or [CYCLE START] key at the same time. Message is cleared.