代码 700233: Fault data transmission for tool management

A serious fault has occurred on reading / writing the tool data. This fault occurs if a tool is cleared from the NC – tool corrections or is not present. Feed Stop Read-in enable missing. 1. Check with the NC – tool corrections whether all tools are present. All tools which are in the Chiron - Tool management should be present. (Set up afresh any missing tools) 2. Switch to manual mode. 3. Press [RESET] key. Message is cleared. A tool overview can be found in the menu Parameters Tool correction Overview If all tools are present and the error occurs frequently, inform the Service department. A serious fault has occurred on reading / writing the tool data. Cause 1: Cause 2: Error occurs as soon as T0 is in the spindle and one attempts, e.g.: to test for a broken tool (for example). Because „T0“ is in the spindle, attribute A of this tool place cannot be found and written over. Feed Stop Read-in enable missing. 1. Change the tool in the spindle (TxxM6). Test tool breakage with a tool in the spindle. 2. Switch to manual mode. 3. Press [RESET] key. Message is cleared. A tool overview can be found in the menu Parameters Tool correction Overview