代碼 700238: Tool not locked (1)

Actuation "Clamp tool" was output, but the response from the monitoring function for "Tool clamped" is not correct. The tool has not been correctly clamped. The error has the following effect: Feed Stop No axis movements possible. Read disable Control reads no further program blocks into memory. If the sensor signals are correct within a monitoring period, the program run is continued. After the monitoring time has elapsed, the machine stops. 1. Check the actuation of the valves "Unclamp tool" and "Clamp tool". 2. Check sensors and corresponding PLC - input signals. Check the voltage value of the analogue sensor. 3. Check the setting of the collet chuck and analogue sensor relative to the adjustment instructions. NOTICE! Adjustment should only be carried out by trained and instructed personnel. 4. As soon as the malfunction is remedied, press the following key: [FEED START] [CYCLE START] Message is cleared and the machining program can be continued.