Código 700307: Check sensor: >magazine place free (changing position)<

Tool changing was terminated, but it was established that the PLC input signal „Magazine place free (changing position)“ was active during the entire changing operation. The switch is monitored for a signal change from [1] to [0] during the tool change. Feed Stop after ending the tool change. The program should be interrupted. 1. Check the setting of the ultrasound sensor according to the setting instructions. NOTICE! Adjustment should only be carried out by trained and instructed personnel. 2. Check the PLC input signal "Magazine place free (changing position)" of the corresponding spindle. 3. Once the switch signals OK again, the error message can be cleared in "manual mode" with the [RESET] key.